LDG AT-897 PLUS Bolt On Autotuner for FT-897D
2 Year Manufacturers Warranty Handled Directly by LDG in Maryland
If you own a Yaesu FT-897 and want a broad range automatic antenna tuner, look no further! The AT-897Plus Autotuner mounts on the side of your FT-897 just like the original equipment. LDG has even added the ability to mount the "feet" on the side of the tuner so when you are transporting your rig by the handle, you can safely set it down and not worry about scratching the case.
The AT-897 is microprocessor controlled and features the tuning ability our customers have come to expect from LDG products. The tuner has a front panel button to initiate the tuning sequence and will bypass the tuner if pressed momentarily. The red LED lights during while the tuner is active.
The AT-897 takes power directly from the CAT port of the FT-897 and provides a second CAT port on the back of the tuner so if you are using another CAT device, hooking it up couldn't be easier.
OPTIONAL ACCESSORIES LIST AT THE BOTTOM OF THIS PAGE:
SPECIFICATIONS:
- Microprocessor controlled
- 2000 fast memories
- Switched L tuning network
- Dual function tune control button
- Continuous coverage 1.8 to 54 MHz
- Power rating HF: 0.1 to 100 Watts
- Provides extra CAT Port
- Tuning time: 1 to 7 seconds, 4 average
- Antenna impedance: 6 to 800 Ohms (Approximately up to 10:1 SWR)
- Tunes nearly any coax fed antenna. Use optional Balun for long wires.
- Power requirements: 11 to 14 volts DC @ 300 milliamps during tune
- Operating voltage supplied via the CAT Port (cable supplied with tuner)
- Enclosure sizes: 11.5 x 3.25 x 1.5 (measured in inches)
- Weight: 2 pounds
|
