LDG AT 7000 Amateur Antenna Tuner

The LDG AT-7000 is is the ideal tuner for your new IC-7000. First, it matches up to 10:1 SWR (3:1 on 6 meters), so just about anything you can feed with coax is good to go. And, it has 2,000 memories, enough for every Dxpedition, RTTY spot and radio buddy you've got, and then some. Just hit the tune button on the radio, and your AT-7000 will set tuner parameters in less than a second if you've been there before. If not, it kicks off a full tuning cycle that will be over in about 3 seconds. Don't need the tuner just now? Then just tap the Tune button briefly, and the tuner goes into bypass. Press it again to bring the tuner back on line -- it's just that simple.

The AT-7000 is just 6.5L x 6.5W x 1.25H inches 1.5 pounds, and gets its DC power directly from the radio. No separate power supply needed. The rear panel features SO-239 input and output. The AT-7000 works with any Icom radio that supports AH-3 or AH-4 Icom antennas. This currently includes the IC-7000, IC-706MkIIG, IC-703Plus, IC-718, IC-746 and IC-756ProIII.

The AT-7000 comes fully assembled, aligned and ready to use. The package includes a 14 inch radio interface cable and a 14 inch coax jumper; you're ready to operate right out of the box.

Specifications:

• 0.1 to 125 watt power range (SSB and CW), 100W on 6M
• 2000 memories for instantaneous band changing.
• Power rating 6M (50 to 54 MHz): 100 watts
• Controlled from Icom Tuner button on radio.
• Compatible with any Icom radio that is AH-4 or AH-3 compatible.
• Compatible with: 7000, 706 (all), 703, 718, 746 and 756 (all).
• Tuning time: 0.1 to 6 seconds full tune, 0.1 seconds memory tune.
• 1.8 to 54.0 MHz coverage. Built-in frequency sensor.
• Tunes 4-800 ohm loads (16-150 on 6M), 4-3200 ohms with optional 4:1 Balun.
• For Dipoles, Verticals, Beams or any Coax Fed Antenna.
• Ready to use with included Icom interface cable and coax jumper.