The Icom AT-140 matches any frequency on every HF marine band. For example, the tuner matches a 23 foot long wire antenna across 1.6–30 MHz
Full automatic tuning! Just push the [TUNE] switch on the transceiver, and
the AT-140 adjusts immediately to the minimum SWR of any frequency on any HF marine band.
The AT-140 allows you HF operation where antenna element length is restricted due to space.
The AT-140 is housed in a durable, completely weather resistant ASA case with a rubber gasket. This antenna
tuner can be conveniently installed both on the deck or in the cabin near the antenna element.
Installation is simple. Just connect the control and antenna cables. You never need to open the cover!
To decrease the tune-up time, the AT-140 automatically stores the matching conditions for up to 45 frequencies. Re-tuning for a memorized frequency takes approximately 1 second. Even if the AT-140 is not used for a week, the built-in super capacitor backs up contents of the 45 memories.
The AT-140 emits low output power during tuning. This feature reduces the possibility of causing interference to other stations.
The tuner through function is built into the AT-140. This function helps improve receiver gain, depending on the antenna element length used, and operating frequency.
Dimensions: 9.1 (W) x 13.4 (H) x 3.1 (D) inches (projections not included)
